1st TCT Workshop

from Monday, 5 October 2015 (13:00) to Tuesday, 6 October 2015 (17:00)
DESY Hamburg

        : Sessions
    /     : Talks
        : Breaks
5 Oct 2015
6 Oct 2015
AM
09:00
Theoretical background of measurements and analysis software (until 10:45) (SR1)
09:00 Theoretical background for measurements - Marko Zavrtanik (Jozef Stefan Institute) Gregor Kramberger (Jozef Stefan Institute)   (SR1)
Slides
09:20 Discussion and Questions   (SR1)
09:30 Simulation from Torino - Nicolo Cartiglia (University of Turin and INFN)   (SR1)
Slides
09:50 Simulation from Ljubljana - Marko Zavrtanik (Jozef Stefan Institute) Gregor Kramberger (Jozef Stefan Institute)   (SR1)
Slides
10:10 Simulation with TRACS - Marcos Fernandes Garcia   (SR1)
Slides
10:25 Common code - Dr Hendrik Jansen (DESY)   (SR1)
Slides
10:45 --- Tea Break ---
11:00
Lab session: Readout boards and temperature control (until 12:30) (Lab2)
11:00 Measurement of edge pulse   (Lab2)
11:30 Readout board: DRS, Oscilloscope   (Lab2)
Slides
12:00 Temperature control and stability: PID controller   (Lab2)
PM
13:00
Registration (until 13:30) (SR3)
13:30
Welcome (until 13:35) (SR3)
13:30 Welcome - Dr Hendrik Jansen (DESY)   (SR3)
Slides
13:35
Introduction to setup and preparation of measurements (until 15:40) (SR3)
13:35 Introduction to TCT and edge-TCT workshop - Susanne Kuehn (Univ. Freiburg) Susanne Kuehn (University of Freiburg)   (SR3)
Slides
13:50 Hardware description: Particulars system - Marko Zavrtanik (Jozef Stefan Institute) Gregor Kramberger (Jozef Stefan Institute)   (SR3)
Slides
14:10 Harware description: CERN system - Christian Gallrapp (CERN)   (SR3)
Slides
14:30 PCBs and mounts for different sensors: diode, strip sensors, CMOS - Dr Hendrik Jansen (DESY)   (SR3)
Slides
14:40 Discussion on setups   (SR3)
14:55 Sensor preparation for edge, backside illumination - Sven Wonsak (University of Liverpool)   (SR3)
Slides
15:05 DAQ + Software operation for particulars - Gregor Kramberger (Jozef Stefan Institute)   (SR3)
15:20 Introduction to finding of focus - Gregor kramberger (Jozef Stefan Institute) Dr Hendrik Jansen (DESY)   (SR3)
15:40 --- Coffee Break ---
16:00
Lab session: DAQ&focus for preparation of scans and sensor preparation (until 18:00) (Lab2/Lab4)
16:00 Cabling, DAQ and software operation of particulars system   (Lab2/Lab4)
17:00 Sensor preparation   (Lab2/Lab4)
19:30 Dinner at Mamma Mia   ()
12:30 --- Lunch Break ---
14:00
Discussion (until 16:00) (SR1)
14:00 Do's and Don'ts - Mr Sven Wonsak (University of Liverpool)   (SR1)
Slides
14:20 Discussion & Questions   (SR1)
14:40 Discussion on common code development - Dr Hendrik Jansen (DESY)   (SR1)